The Uchida VS-25 Paper Drills is highly
accurate and designed with simplicity for safe and easy use. By rotating the pre-programmed pitch bar dial, the desirable hole pitch can be selected.
The ergonomically designed lever allows for easy and accurate punching of all stocks. One, two, three or four holes are perfectly positioned and choice of bit sizes up to 6 mm can be used. The ability to adjust the back margin increases the flexibility of the work the Uchida VS-25 can take on. A programmable element covering the most commonly needed sizes keeps any training to a minimum.
The self-centring guides ensure that the paper is always in the correct position when drilling. Programmable feature keeps the operation simple. The 50 mm pile height provides the productivity needed, while a clamp will hold the paper to prevent movement while drilling. Waste is collected in a container for convenience and ease of emptying. Teflon coated drill bits are available for drilling difficult stocks.
Machine Features:
- Drilling position automatically determined
- Self centring sliding table and paper clamp to secure paper in place
- Multiple hole drilling with six different pre-set spacing’s available
- Interchangeable drill bits
- Adjustable back margin
- Pre-programmed pitch bar
- Desirable hole pitch selection
- Drill depth 50mm (500 sheets).
- Paper clamp bar.
- Takes drill bit sizes 3-6 mm as standard.
- Teflon coated drill bits available to aid drilling of difficult stock.
Version | Phase 1 | Phase 2 | Phase 3 | Phase 4 | Phase 5 Metric | 2 holes: 80 mm| 4 holes: 80 mm| 4 holes: 45-65-45 mm| 6 holes: 19-19-51-19-19 mm| 34 holes: 8,47 mm Imperial (inch) | 2 holes: 2,3/4" | 3 holes: 4,1/4" | 3 holes: 3,1/2" | 3 holes: 2,3/4" | 22 holes: 1/2" Pitch assortment of pre-programmed pitch bar. [attr colspan=6]
